GroovyBoovy
Junior Member
- Messages
- 61
Hello All
I am attempting to wind down my suspension to what should be a proper ride height. , I am unable to compress the front coils enough so I can wind down the bottom coil support thing, I have undone the locking nut, so next step seems to be remove the coil-over unit
A few good guides on how to do this, however, after removing the suspension sensor, I can get a 22mm socket on the upper ball joint, but there is no room to attach my torque wrench, or any other kind of wrench to undo it, are you soposed to remove the plate for hub holder? Or is there another way? Have I missed something?
Thanks
Rob
I am attempting to wind down my suspension to what should be a proper ride height. , I am unable to compress the front coils enough so I can wind down the bottom coil support thing, I have undone the locking nut, so next step seems to be remove the coil-over unit
A few good guides on how to do this, however, after removing the suspension sensor, I can get a 22mm socket on the upper ball joint, but there is no room to attach my torque wrench, or any other kind of wrench to undo it, are you soposed to remove the plate for hub holder? Or is there another way? Have I missed something?
Thanks
Rob