Search results

  1. 8

    1980 Quattroporte III for sale

    The car is in San Diego, California. I think $4000 will take it.
  2. 8

    1980 Quattroporte III for sale

    Only the QP III is for sale.
  3. 8

    1980 Quattroporte III for sale

    Hello, Here is a 1980 Quattroporte with about 36,000 miles. The car was stored in a warehouse in 2016 and wasn't driven since. Body has NO rust NO dings but paint is pealing, mainly because of the clearcoat. Interior is quite good and no tares on seats. I tried to start it and turned out that...
  4. 8

    Maserati Khamsin Clutch

    Following the advise of Evan, I emailed David at McGrath Maserati in the UK. He suggested to look into the pin securing the clutch pivot arm to the shaft, because they have a tendency to snap. Turns out that this was the problem. However the previous owner simply welded the shaft to the lever...
  5. 8

    Maserati Khamsin Clutch

    I was under the car only once but as I recall; the piston rod is connected to the clutch lever and I was able to move it back and forth. In case of a 'normal' slave cylinder, the lever is spring loaded and it pushed back against the rod coming out of the piston - here it was different, I...
  6. 8

    Maserati Khamsin Clutch

    Is there a workshop manual for the Khamsin? I searched over the internet and couldn't find one (even pdf).
  7. 8

    Maserati Khamsin Clutch

    Unfortunately I'm California. Here is a photo of the Khamsin.
  8. 8

    Maserati Khamsin Clutch

    Dear Experts, Yesterday, the clutch on my 1975 Khamsin stopped working. The pedal became stiff and cannot be pushed in. I looked under the car, and was able to move the clutch lever but looks like the slave piston got stuck? This is not a simple system, so before I jump and replace the slave...
  9. 8

    Biturbo 2.8 Speedometer

    Dear Oneball, Thank you for this great info. Is there a similar description to diagnose the speedometer? Looks like in my case there is power to the sensor but nothing moves at the speedometer end. I don't mind buying a new sensor but first would like to make sure that the speedo is OK. By the...
  10. 8

    Biturbo 2.8 Speedometer

    Hello Oneball, Thank you for your advise. Today I checked the Volts in and out of the sensor (at the exit of the gearbox) and it was 2.23V in and out. Then I disconnected the red and white wires and the red read 2.23V and the white zero. So, I think, if there is some coil inside the sensor...
  11. 8

    Biturbo 2.8 Speedometer

    Hello, Got a 'new' 1989 Biturbo Spyder and the speedometer is not working. I pulled the instrument panel and moved all connectors - but nothing changed. Then I went under the car and checked the sensor at the end of the gearbox. It has two wires and all look like brand new. The car has only...