3200 door glass

[RossWA]

Hi Guys,

It must be my turn for odd electrical problems !

When I lift the drives side door handle the window glass only drops a couple on MM, not the CM that it used to.
The odd thing is that if I have the door open and raise the window glass it goes all the way to the top and then drops by the correct amount -the way it should.

I am aware that there are a number of switches inside the door that control the position of the glass and a computer too, but why would the glass drop properly when the door is open and not when it is closed?
The glass in not binding on the frame, it just appears to not be driving down for long enough.

This problem started at the same time as I lost my low beam headlights, which was after I had the Throttle Body refurbished. I bet there is some obscure fuse that has blown and is causing my problems.

Any thoughts?

Cheers

Ross

 

[hodroyd]

The window thing sometimes does happen, have you tried a Power Off Reset (switch in the boot), see if that corrects the issue, leave it off for a few minutes then try again..!!

 

[highlander]

not sure if works with masers but an old alfa trick to reset the window memories was put both windows full down and hold both the buttons down for 10 secs..........worth a try.

 

[CatmanV2]

Indeed this used to work.

C