360 F1 Reverse Lever - does this also fit the 4200?

[Parisien]

http://www.hillengineering.co.uk/ca....html?osCsid=3ff4ff811f16329b06efe4b09b6acf00

Just throwing this up for clarification


P

 

[Parisien]

And one for the QP anyways!

Forum 10% discount applies


http://www.hillengineering.co.uk/ca....html?osCsid=3ff4ff811f16329b06efe4b09b6acf00


P

 

[lozcb]

http://www.hillengineering.co.uk/ca....html?osCsid=3ff4ff811f16329b06efe4b09b6acf00

Just throwing this up for clarification


P

Not had one break yet in 5 years of ownership , so never really considered it a problem , any problems ive come across before have been microswicth related rather than the lever it self



regards loz

 

[Parisien]

Its been mentioned a few times on ML Loz......so seems to be a need for them


P

 

[safrane]

You on commision P? ;o)

 

[Parisien]

.....oh yeah.....is that the 90% commission you mean ...after you take off the forums 10% discount...............................


P

 

[lozcb]

Its been mentioned a few times on ML Loz......so seems to be a need for them


P

In that case just might beg the question , its a yank related problem , over weight handfisted fingers like hotdogs and as much finnesse as a blind one legged donkey springs to mind Frank .and that was just off the tip of my tongue , give me five and i'll put some proper thought into the equation , tell you what , wait till tomorrow we'll have breafast meet brainstorming session followed by a video conference with the office next door , if you get my drift


regards loz

 

[Parisien]

I'd put it down to the quaint USA custom of valet parking of prestige cars...........................all it takes is one hefty YANK ( pun intended) and its bust!!!!!!






P

 

[Klive]

From a 4200 perspective there's a screw underneath that can come loose and then fall out, leaving you with an unbroken lever in your hand. You just need to get into the centre console to refit it.