Definitely round on mine - and definitely fit for the skip. I took the picture at Giallo and neglected to measure it like a complete numpty! I am guessing it’s 51mm diameter but when you still think in old measure you begin to doubt yourself.
Sounds more plausible. I will just order some in and hope. I can always send it back if it doesn't fit.Mine's a normal 3200GT
I measured where the pipe attaches to the front duct and got 61mm and measured a free bit of pipe next to a strengthening wire and got 60mm
Maybe I was being sizist!?No idea where the last post was moderated to or why? But 60mm it is!
Check out: https://www.merlinmotorsport.co.uk/p/revotec-red-single-layer-silicone-ducting-per-metre-rev-rsl
Hi Bob, if you are talking about the worm drive on the jubilee clip it should be hexagon shaped so you can gain extra purchase by using a 5, 6 or 7 mm socket on it.Bucket list job...
What's the best way to get off a screwed-up circlip without damaging it? I can saw through the side of the thread casing to release it but this seems a little brutal. The head on the circlip had been overtightened on one side of the brake duct to the front disc - and now wont take the head of a slot screwdriver cleanly - so I cannot get enough purchase to turn release it - even with the aid of a good soaking in Plus Gas. I want to get the jubillee clip off cleanly and not risk damaging the air main cooling scoop duct to the disc with a cutter through the band - latest brainwave.
Make sense? Any ideas?
Thanks Mike,Hi Bob, if you are talking about the worm drive on the jubilee clip it should be hexagon shaped so you can gain extra purchase by using a 5, 6 or 7 mm socket on it.
HTH
Mike