You can get the bearings for them the part is SKF GE15C.
A few vendors offer the entire tie rod arms which are Formula Dynamics, AS Motorsports and Auto Ricambi from the top of my head.
Sockets and rods I have; still figuring out the outer and crucial ball joint solution... Got a bit distracted with work lately!
Thats what I had done with mine, not hard to replace either.Just get the SFK bearings they last longer than the FD solution and are much cheaper.
Thats what I had done with mine, not hard to replace either.
What about the one I sent you? Basically a GE15C in rod end form.
For front lower boot I used these, size XL,
View attachment 85831
If the ball joint has play the front lower arms need replaced, the front upper ball joint can be replaced relatively cheaply.
Not sure about uppers but if you measure inner and outer sizes I’m sure Rhino or similar could match themWhich site is it? The picture is quite small and I can't read the url-adress.
Are the upper joints as big as the lower? Can I use the same covers? Because I have no play in the joints, the dust covers are just broke after 16years....
Was 3-4 years ago but remember they fitted nicely and are designed to stretch as universal type.Do the XL ones fits nicely or do you have to stretch them already?
Because I found some with 37 and 15mm nearby, so 3mm less at both sides. Should I give them a try?
And do you also now if the nut at the upper ball joint is the same as at the bottom?
At eurospares there is no information regarding the nuts if they are the same.
Cheers Newton, much appreciated.M12 fine pitch if you are referring to the stud from the outer lower ball joint through the hub, tie rod ball joint etc.
The way to prevent grief with the steering, drive shaft and suspension boots is to spray them, probably at least once a year, with silicon spray. It can also be used to protect rubber parts like the $$$$ door seals on Spyder's. I've done this for years.
Spray the large boots on the rack and the tie rod end boots.Where would you spray the steering? Open the plastic parts around the column ?