Recent content by Gecara8183

Are you still looking for a new slave cylinder.

Depending on condition of your back plates I found the locating pin and spring came loose. Backplate rust out so worth a coat of hammerite. I had to repair and modify my back plate and retainers as they were NLA. PS only joking about weetabix. What are hand brake drums like Sent from my...

Weetabix or shorter spanner you shouldn't need to remove caliper if just changing pads Sent from my SM-G781B using Tapatalk

Hi not really able to comment as not been using car. Its up for sale. I think common solution is to upgrade fuse. But if it keeps blowing it would appear something is faulty. Sent from my SM-G781B using Tapatalk

Whilst we have a exhaust thread going. Does any of your car centre e haust box rattle at ant time Sent from my SM-G781B using Tapatalk

They look good solution Sent from my SM-G781B using Tapatalk

With out a good look but from memory would it be possible to cut flares of and measure pipe to put a sleeve on with some quality exhaust band clamps Sent from my SM-G781B using Tapatalk

If 3200 you can wriggle out the rear drive shafts. Front can be cleaned from back of disc. Hope that helps Sent from my SM-G781B using Tapatalk

Not sure if obd2 reader would id fault. Depends on the quality of the reader I think. Sent from my SM-G781B using Tapatalk

[emoji1696] light should go out once signal is received by sensors. If not may be the ECU on top of the pump. Sent from my SM-G781B using Tapatalk

Only in the dry Sent from my SM-G781B using Tapatalk

Until work is done. Sent from my SM-G781B using Tapatalk

May have suggested this previously replace both reluctor rings on the rear. Google a company called reluctor rings pattern part were 80 quid a pair. You can't change the front but you can clean them well on the car. I would disconnect abs as in my own experience the few times the error light...

I have sold a couple new remanufacture condensers. Look on ebay Sent from my SM-G781B using Tapatalk

Hi from my experience they all fluctuate a bit on idle. To improve mine I changed all the non return valves in the vacum system which improved it significantly Sent from my SM-G781B using Tapatalk