Ghibli Cup suspension settings

spacecadet

Member
Messages
378
Anyone knows the suspension settings of the Cup?

Also could someone with a Cup please measure the right height front and rear? Distance from wheel center / wheel top to bottom of fender above.

Thanks
 

del mar

Junior Member
Messages
257
Floor to wheel arch

Front 61.5cm

Rear just shy of 64cm

Wheel from top of rim to arch

Front 9.3cm

Rear 10.5cm
 

alfatwo

Member
Messages
5,517
I think there a bit more to it than that guys, how about castor, camber, toe etc front and rear

Dave
 

spacecadet

Member
Messages
378
Thanks Del

Sure, I would like to see those as well, but only when getting a full alignment which is further down the road. I wanted to do a rough verification first, and the least possible preload when tightening the bolts in the rubber mounts of the control arm, ARB, etc. No 4 post lift at home, so I have to lift the front and rear up from the jack stand via the wheels. But I just realized that without having the engine in it's place, I won't get these numbers...
 

alfatwo

Member
Messages
5,517
Thanks Del

Sure, I would like to see those as well, but only when getting a full alignment which is further down the road. I wanted to do a rough verification first, and the least possible preload when tightening the bolts in the rubber mounts of the control arm, ARB, etc. No 4 post lift at home, so I have to lift the front and rear up from the jack stand via the wheels. But I just realized that without having the engine in it's place, I won't get these numbers...

Stop the whole thing mate!

The car needs to be complete.... with engine, oil ,water and a half full fuel tank, everything.

Then you can do your corner weighting!

Dave
 

spacecadet

Member
Messages
378
Right, but only simple castor, camber, toe-in, no corner weighting for me, I don't have coil overs.