Hi Conaero
the bolster is top of my list of jobs to do and the kit you show is probably exactly what i need, struggling with how to get a clour sample to hm though.
if you take the drivers seat out our one of the rear benches, turn it over and there will be a bit you can cut off. They need a 2cm square bit only.
Have a look on YouTube for a guide, but you need to prepare the surface to take the pigment.
It looks like yours is quite rough, you need to flatten it off with a scotch pad, just go easy and don't go through the leather.
Once you have it smooth, clean thoroughly with the blue cleanser, allow to dry the paint the bad bits with a brush liberally. Shake the pigment too its a suspension and if you don't mix it the colour will be blotchy.
Leave each coat an hour to dry then when you have covered the bad bits use a sponge to colour the entire bolster, 3 coats should do it. Clean the rest if the seat too with the cleanser as you will be amazed how bright the new paint is and what dirt does to the existing colour.
For best results buy a craft airbrush, Hobby Craft do one for £20. This will give a more even finish than the sponge method.
Go to 9.00:
[video=youtube;MTwgTHwCTZQ]http://www.youtube.com/watch?v=MTwgTHwCTZQ&sns=em[/video]