Harvey_Tim
Member
- Messages
- 216
Hi
Apologies if there are existing threads on this subject but I don’t seem to have much luck with the search function on this forum!
Whilst changing my battery today I notice that my EPB unit was basically floating free as all 4 of the mounting “pads” have separated at the rubber joint.
My understanding is that these are just a threaded shaft attached to a rubber part and then another threaded shaft bolted at both ends and in my case all 4 rubber sections have failed leaving the EPB unit unattached to anything.
Firstly, is this a common problem and if left as is for a period of time is it going to cause issues with my EPB unit?
What is involved in replacing these mounts, I had a quick look underneath the car and everything is obscured by a large heat shield. Is it just a case of removing this heat shield replacing the mounts or is there much more to it than that? - i.e. do you have to remove loads of other bits just to remove the heat shield etc. ?
Any advice appreciated.
Many thanks,
Tim
Apologies if there are existing threads on this subject but I don’t seem to have much luck with the search function on this forum!
Whilst changing my battery today I notice that my EPB unit was basically floating free as all 4 of the mounting “pads” have separated at the rubber joint.
My understanding is that these are just a threaded shaft attached to a rubber part and then another threaded shaft bolted at both ends and in my case all 4 rubber sections have failed leaving the EPB unit unattached to anything.
Firstly, is this a common problem and if left as is for a period of time is it going to cause issues with my EPB unit?
What is involved in replacing these mounts, I had a quick look underneath the car and everything is obscured by a large heat shield. Is it just a case of removing this heat shield replacing the mounts or is there much more to it than that? - i.e. do you have to remove loads of other bits just to remove the heat shield etc. ?
Any advice appreciated.
Many thanks,
Tim