3200GT turbo removal

[Pratto1026]

Hello,
looking to have both turbo's rebuilt/serviced as one turbo has a noisy bearing.
Is it possible to remove each turbo by removing the sub frame assembly? any insight would be greatly appreciated.

 

[davy83]

I removed the subframe to get into my turbos, and it worked fine. Its a lot of work. There is an owner on this forum who managed it without removing the subframe, but I cannot imagine that would be an easy job.

 

[VelluMasa]

I can be done without removing any major parts (not even valve covers or subframe) but its very time consuming and tight places. Done it with out lift.
But where you will find parts for those? I have build some turbos over the years and I would say at these are bit harder then normal ones. Even Europe IHI distributor sayed at these parts was stopped in 2019 from production. I did find it cheaper to buy new ones than rebuild using some old parts.