I'm sure they could be modelled and printed. I'd buy a pair (subject to cost...)is it possible to have a STL (3d model) of R or 1 button from gearbox control ?
Do you have pics of the completed bits, would be great to see the transformationHe’s working on all mine at the moment..
View attachment 82628View attachment 82629View attachment 82630
Roland did my R&1 a while back. Finish was spot on. You cannot tell any difference.Do you have pics of the completed bits, would be great to see the transformation
I’ve seen laser printed stickers and theyre identical. Might call into my local printer and ask them to make them up for meWho is going to get some 1/R buttons printed?
Check with Roland if he still does the service otherwise there are some others that can do the job. Roland did the switches on my GS 2 years ago and they’re holding up great.Who is going to get some 1/R buttons printed?
I sent him an email a while ago but no response. My buttons look fine but if it was cheap I would refresh themCheck with Roland if he still does the service otherwise there are some others that can do the job. Roland did the switches on my GS 2 years ago and they’re holding up great.
Call him, written word not his forte.I sent him an email a while ago but no response. My buttons look fine but if it was cheap I would refresh them