Im going to pull the car back into the garage and check it out again, its very cramped in there. Its blistering hot outside in Florida right now. Removing the entire compressor is quite the job having to remove the manifolds and lifting the engine. Im really trying to avoid it if possible but...
I was tightening the ground strap but it wasnt running. Not sure if it's related. thanks for the tip, Ill seee if I can locate it. Are the units rebuildable by a shop?
Hey everyone,
I was tightening the ground strap on my 2005 Coupe and the ABS and Stability control lights are now on and return after clearing. My Launch tool is showing a code C1266 ABS Pump DTC. My searches are returning a bad ABS module. Can someone tell me where the module is located? I...
I reconnected the battery today and the seat started moving again, though the motor is making alot more noise. Ill add replacing the motor with the porsche motor on my to do list! Thanks for the help!
Looking for some assistance please. Got into my 4200 and started the car, my drivers seat started moving to the full foward position. No response from the seat controls. After a few minutes of fidgeting I started smelling electrical burning smell. Shut off the car and pulled the battery. Anyone...
$234 including tax and shipping to the US. I emailed my rep there, he usually gets me 10-15% off the website prices.
Scuderia Parts Accelerator Potentiometer
Conaero, this got me thinking about the hesitation/stalling issue Ive been troubleshooting. I didn't consider the drive-by-wire components. I did a quick test with the car in neutral and blipping the throttle. If I pushed the accelerator slowly, revs would climb. If i pushed it any faster...
Thanks for the reply conaero. I understand the intake air temp sensor is integral to the MAF. So the ambient air sensor is not utilized by the ECM then? Its confusing because I'm accessing the ECM module to get the live ambient air sensor value which is wrong???
Hello All,
Im hoping someone could help answer this question definitively.
Does ECM utilize ambient air temperature sensor?
I'm trying to chase down throttle hesitation that is causing stalling. During diagnosis I found my intake temp reading are about 10 degrees off, I have a new MAF...